-
December 10th, 2003, 10:58 AM
#1
Inactive Member
I have an electrical fuel pressure guage and recently the pressure on the guage has dropped about 20 psi standard there it acts as if you just have to add 20psi to the reading to get the correct reading accross the board.
Question: Is this a problem with the sending unit or the guage and if it is the sending unit where can i get one to purchase? 100psi units respectively.
zort
-
December 10th, 2003, 12:46 PM
#2
Senior Hostboard Member
What kind of fuel pressure gauge is it?
Decent chance it is the sending unit.
-
December 10th, 2003, 01:20 PM
#3
Inactive Member
It is an autometer. Is there any way of clean the sending unit or "fixing" it?
WHere can i get one new?
zort
-
December 10th, 2003, 05:02 PM
#4
Inactive Member
-
December 10th, 2003, 07:37 PM
#5
Inactive Member
is it half sweep or full sweep?
The half sweep gauges were recalled because of the sending unit, the full sweeps didnt have that problem...
I would contact autometer. It should be a warrenty thing regardless. (especially if it is the recalled half-sweep)
-
February 3rd, 2004, 12:49 PM
#6
Inactive Member
Guys, i sent the guage to autometer for the replacement. Thanks. There was a re-call.
zort
<font color="#a62a2a" size="1">[ February 03, 2004 08:50 AM: Message edited by: zort ]</font>
-
February 5th, 2004, 08:32 PM
#7
Inactive Member
those half sweeps were horrible gauges.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks